2002-475/011-000

PIDG R 22-16 COMM 22-18 MIL 10

Crimp contact, female, 1 MM2

Crimp contact, female, 0.5 MM2

Housings, bulkhead mounting, 10 B, aluminium die-cast, powder-coated, IP65

Housings, bulkhead mounting, 24 B, aluminium die-cast, powder-coated, IP65

D-Sub, Crimp contact, Turned; Female; Copper alloy; Conductor cross-section: 0.25

CABLE CLAMP METAL HOOD 9-37P D

CABLE CLAMP METAL HOOD 9-37P D

4-conductor through terminal block; 2.5 mm²; suitable for Ex e II applications; side and center marking; for DIN-rail 35 x 15 and 35 x 7.5; Push-in CAGE CLAMP®; 2,50 mm²; gray

End and intermediate plate; 0.8 mm thick; gray

2-conductor disconnect/test terminal block; with additional jumper position; orange disconnect link; for DIN-rail 35 x 15 and 35 x 7.5; 2.5 mm²; Push-in CAGE CLAMP®; 2,50 mm²; gray

Jumper; 3-way; insulated; light gray

Staggered jumper; 2-way; from 1 to 3; insulated; light gray

Screwless end stop; 6 mm wide; for DIN-rail 35 x 15 and 35 x 7.5; gray

1-conductor female connector; CAGE CLAMP®; 2.5 mm²; Pin spacing 5 mm; 4-pole; 100% protected against mismating; Lateral locking levers; 2,50 mm²; light gray

Strain relief plate; for female and male connectors; 12.5 mm wide; 1 part; Pin spacing 3.5 mm; light gray

WMB marking card; as card; MARKED; 1 ... 10 (10x); not stretchable; Horizontal marking; snap-on type; white

WMB marking card; as card; MARKED; 11 ... 20 (10x); not stretchable; Horizontal marking; snap-on type; white